Articles

… CUT TO THE CHASE … !!

Microphone use
  • Plug the mic into the unit
  • Set the input selector to -45
  • Monitor the input, (Push monitor select button "IN")
  • Set the input selector and trim so that the average signal is around the yellow led.
  • Set the Threshold control for desired limiting.
  • Set the attack, release and ratio controls to 12:00.
  • Monitor the output signal, (Put the monitor select button in the "Out" position).
  • Set the output gain makeup control for around the yellow LED.
Line level use
  • Plug the Line level signal into the input of the BA-660.
  • Set the monitor selector switch to the input (in) position
  • Set the input selector and trim controls so that the signal is lighting the the
  • Yellow on the peaks.
  • Set the input selector and trim so that the average signal is around the yellow led.
  • Set the Threshold control for desired limiting.
  • Set the attack, release and ratio controls to 12:00
  • Monitor the output signal, (Put the monitor select button in the "Out" position)
  • Set the output gain makeup control for around the yellow LED.